usb 1-1.3: device not accepting address 43, error -71 usb 1-1.3: Device not responding to setup address. This is completely out of my understanding.Įrror when I connected again usb 1-1.3: new full-speed USB device number 43 using xhci_hcd However, the camera still does not show under lsusb. This morning somehow the camera attached message was logged in the dmesg but the command fswebcam gave following error: - Opening /dev/video0.Īdjusting resolution from 384x288 to 320x240. Just for the information, below is the output of dmesg from Ubuntu laptop where this camera works:Īnd output of lsusb: Bus 001 Device 014: ID 05ca:18c3 Ricoh Co., Ltd USB2.0 Camera I tried enabling the camera module from raspi-config with no changes in the outcome. Some where I found following command vcgencmd get_camera which gives: supported=1 detected=0 I checked dmesg I don't see any trace of the USB device being plugged in.Īlso, lsusb command does not list the device.
I installed fswebcam which upon execution gives below error: - Opening /dev/video0. I have a Raspberry PI 4 (4GB) with Raspbian OS lite installed.
This camera works properly on my Ubuntu laptop. I have a laptop camera wired to a USB cable.
0 kommentar(er)
